56 VOLT LITHIUM-ION CORDLESS LINE TRIMMER — STX4200 13
the slots in the lower cover assembly with the
release tabs (Fig. O). Press the lower cover assembly
until it snaps into place with a distinct click sound.
4. Follow the instructions in “Line replacement” to
reload the cutting line.
TRIMMER HEAD REPLACEMENT
WARNING: If the head loosens after it is fixed in
position, replace it immediately. Never use a trimmer with
a loose cutting attachment. Replace a cracked, damaged
or worn out cutting head immediately, even if damage
is limited to superficial cracks. Such attachments may
shatter at high speed and cause serious injury.
Know the trimmer head (Fig. P)
P-1 Lower Cover Assembly P-4 Spring
P-2 Cutting Line P-5 Upper Cover
P-3 Spool Assembly P-6 Drive Shaft
Remove the trimmer head (Fig. Q1)
1. Remove the battery pack.
2. Insert the hex wrench provided into the shaft-locking
hole on the motor housing to act as a shaft lock,
hold it with one hand and try to push it inward. At
the same time, use the other hand to rotate the
trimmer head until the hex wrench is fully inserted.
Q-1 Shaft-locking Hole Q-2 Shaft Lock
3. Keep holding the hex wrench, rotate the trimmer
head clockwise to remove it.
Install the trimmer head
1. Lay the trimmer on the ground or the floor with the
drive shaft facing upward.
2. Align the screw hole on the trimmer head with the
drive shaft, install the trimmer head onto the shaft
by rotating it counterclockwise (Fig. Q2).
3. Install the hex wrench into the shaft-locking hole
per the previous section, “Remove the trimmer
head”. Continue to tighten the trimmer head
counterclockwise until fully tightened (Fig. Q3).
MAINTENANCE
WARNING: Before inspecting, cleaning or servicing
the unit, stop the motor, wait for all moving parts to
stop, and remove the battery pack. Failure to follow
these instructions can result in serious personal injury or
property damage.
WARNING: When servicing, use only identical
replacement parts. Use of any other parts may create a
hazard or cause product damage. To ensure safety and
reliability, all repairs should be performed by a qualified
service technician.
CLEAN THE MACHINE
◾ Clean the unit using a damp cloth with a mild
detergent.
◾ Do not use any strong detergents on the plastic
housing or the handle. They can be damaged by
certain aromatic oils, such as pine and lemon, and by
solvents such as kerosene. Moisture can also cause
a shock hazard. Wipe off any moisture with a soft dry
cloth.
◾ Clear any grass that may have wrapped itself around
the motor shaft or trimmer head.
◾ Use a small brush or the air discharge of a small
vacuum cleaner brush to clean the air vents on the
rear housing.
◾ Keep the air vents free of obstructions.
SHARPENING THE LINE-CUTTING BLADE
WARNING: Always protect your hands by wearing
heavy gloves when performing any maintenance on the
line-cutting blade.
1. Remove the battery pack.
2. Remove the line-cutting blade from the guard.
3. Secure the blade in a vise.
4. Wear proper eye protection and gloves and be
careful not to cut yourself.
5. Carefully file the cutting edges of the blade with a
fine-tooth file or sharpening stone, being careful to
maintain the original cutting-edge angle.
6. Reinstall the blade onto the guard and secure it in
place with the two screws.
Присъединете се към разговора за този продукт
Тук можете да споделите какво мислите за EGO STX4200 Тример за трева. Ако имате въпрос, първо прочетете внимателно ръководството. Заявката за ръководство може да бъде направена чрез нашата форма за контакт.